Recommended products
Circuit Sub-metering
Engage Circuit Sub-metering Kit
$59.95
Solar Sub-metering Kit
Engage Solar Sub-metering Kit
$79.95
Measure the electrical current
Efergy Sensors are designed to measure and report the AC current flowing in a single conductor. It is very easy to install just clamp it on a conductor cable and plug it into the transmitter (it clamps around the insulated wire and measures the magnetic field).
The clamps only measure current, so the voltage value must be estimated. On most of our energy monitors you can set and adjust the voltage. The default setting will usually be 240 volts which is the typical electricity supply voltage in Australia.
Specs
FEATURES
- Clip around the cable to monitor the current that runs through it
- Add it on your Engage system to monitor up to 5 circuits
- Add sensors to monitor three-phased power supply
- Ideal for residential properties
- Easy and quick to install
COMPATIBILITY
Compatible with existing Efergy Elite, E2 and Engage energy monitors (not the TPM model)
DYI INSTALLATION
Yes
THREE-PHASE
Three Phase Compatible
DEVICE SPECS
- Model: XL-SR
- Dimensions: 38x51x38mm
- Weight: 60g
- Internal diameter: Max. 19mm
- Nominal: 120A Max. 200A
- Voltage Range: 110V-300V
- CAT II 600V